R-4104.A
CARE FOR STARTING REPAIR
CARE FOR STARTING REPAI R
• When carrying the microscope, hold its arm with one hand. :rnd 1ts base with the other.
eFor replacement and others of the lamp bulb, do not touch it. aiter putting out the lamp, directly with the fingers.
eWltlle the lamp is lighted, never bring any inflammable substances such as alcohol, gasoline, thinner, etc. near to the lamp housing.
•Take every caution in handling against shock.
•Be careful not to leave dust, t1nger marks, etc. on the tenses, lamp bulb, etc.
eMake sure of the power source voltage to be used (for example: UNE IOOV, LAMP 6V, 20W), referring to the indication found on the transformer.
•Before replacing the fuse in the transformer, pull out the plug of the power source cord.
•For cleaning the lens surfaces, füst remove dust, using a sott haJr brush, or wipe it off lightly, using a gauze.
•Only for removing finger marks or grease, use a soft, clean cotton cloth, specified lens tissue or gauze, soaked with a bit of absolute alcohol (ethanol or methanol).
e For cleaning the parts painted or made of plastic, avoid the use of such organic solvents as alcohol, ether, thinner, etc.
eDo not use other tools other than the specified, except for an unavoidable case.
•Apply only specified oils to the parts, r"ferring to the lubricant table, to keep up the efficiency of the instrument.