Toshiba DKT3000 manual Station Call Forward Procedures, To change your Pass Code

Call Forward Advanced Operation

Station Call Forward Procedures

The following table contains Call Forward Button sequences. You can do a Call Forward function by, one, entering the button sequence as described, or two, by programming a Flexible Button to perform the sequence. See “Programming Feature Buttons” on page 67 for instructions on programming a Flexible Button.

Some Call Forward features require a Pass Code entry. Use the following procedure to change your Pass Code.

➤To change your Pass Code

➤Press Extension button + #670 + ext. no. + old Pass Code (1~15 digits) + # + new Pass Code (1~15 digits) + #.

➤To use the Call Forward button sequence

➤Follow the instructions in the following table, shown under “Button Sequence.” Some features require additional input, such as:

♦Destination – If the destination is an outside number, press # after entering the destination. The CTX accepts destination numbers of up to 32 digits.

♦Timer – This is a two digit entry representing how long (eight to 60 seconds) your telephone should ring before forwarding the call. If you enter one digit, you must press # after entering the single digit.

♦Pass Code – A four-digit code established by system programming to prevent unauthorised changes. The code applies to the station to be forwarded; not to the station entering the code.

Note In the following table, (Tone) means that a confirmation tone will play at that point in the sequence.

32 Strata CTX DKT3000/2000-Series Digital Telephone October 2002