6.If the IPT is connected to a router or other gateway device, press )%. Enter the router address, then press +ROG. Only used if Step 3, above, is set for manual setting.
7.Press )%. Enter a Station ID for the IPT and press +ROG. This is usually your telephone’s primary number (PDN).
8.Press )% to enter the CTX Strata Net node number of the CTX node that contains the
9.Press )% for BIPU IP address mode. Press one of the following:
: manual setting, then press +ROG. Press )%
then press +ROG. (e.g., if the BIPU IP address is format ).
: auto setting by broadcast, then press +ROG.
and enter the BIPU IP address, “192.168.1.241,” enter it in this
: auto setting by multicast (IPT doesn’t support multicast setting in this first release), then press +ROG.
10.Press +ROG again to set all the above data.
11.Go
Note See “IP Telephone Start Up Sequence” below for an explanation of the LCDs that you will see during this procedure.
Strata CTX DKT/IPT Telephone 11/03 | 97 |