VTech CS2111-11, CS2112 user manual Battery

Page 37

Battery

After the battery is fully charged for 16 hours, you can expect the following performance:

	Operation	Operating time

	While in use (talking)	3.5 hours

	While not in use (standby*)	3.5 days

*Handset is off the telephone base but not in use.
The battery needs charging when:

•A new battery is installed in the handset.

•The handset beeps.

•LOW BATTERY and the battery low indicator are displayed on the handset screen.

CAUTION:

To reduce the risk of fire or injury, read and follow these instructions:

•Use only the battery provided or equivalent. To order a replacement, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

•Do not dispose of the battery(ies) in a fire. Check with local waste management codes for special disposal instructions.

•Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.

•Exercise care in handling batteries in order not to create a short circuit with conductive materials such as rings, bracelets, and keys. The battery and/or conductor may overheat and cause burns.

•Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO WATER OR ANY TYPE OF MOISTURE.

www.vtechphones.com

33

Appendix

Image 37

Contents User’s manual Congratulations Table of contents Iii Handset Power adapter Cover Parts checklistBattery Telephone base Telephone baseDSL filter not included for DSL users Telephone line cord Telephone base installationBattery installation and charging Wall mounting Press to scroll up while in programming mode Press to scroll down while in programming modeHandset layout Press to store a programming option or a directory entryPress to page the handset Telephone base layoutDate and time Event of a power failure, the time may need to be resetRinger Ringer volumeHome area code Dial modeLanguage Clear voicemail Make calls VolumeAnswer calls End callsTemporary tone dialing Call waitingFind handset RedialStore a directory entry DirectoryCharacter chart Review the directory Edit a directory entry Delete a directory entry Dial a number from the directory Copy a directory entry into speed dialStore a speed dial entry Speed dialCursor appears at the end of the name. Use the dial pad Edit a speed dial entryDial a speed dial number Delete a speed dial entryReassign speed dial locations About caller ID Call log Make a call log entry ready to dial Review the call logDial a call log number Save a call log entry to the directory Delete an entry Delete from the call logCaller is blocking the telephone number information Call log display screen messagesCaller is blocking the name and number information Handset display screen messages Battery Important safety instructions My telephone does not TroubleshootingWork at all Handset to the telephone base after use Telephone base for 16 hoursNot accept charge Telephone base and charge for 16 hoursTelephone company Place Incoming callCannot dial out First, try all the above suggestions See Dial mode on page 9 to set the dial typeMy calls cut in and out When I am usingApart from each other, or use a different surge protector Charges may applyHear other calls when Using the telephoneKeys or buttons work System does not ID serviceReceive caller ID, or Company Caller ID during callTo dial Caller ID entries do notNumbers before dialing or saving the telephone number My cordless handsetCommon cure for Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsRbrc seal Technical specifications Index Appendix 91-001545-050-100