VTech CS2111-11, CS2112 user manual Battery installation and charging

Page 7

Getting started

Battery installation and charging

Install the battery as shown below. The battery may have enough charge for short calls. For best performance, charge the battery for at least 16 hours before use. When the battery power is low, the handset will beep, LOW BATTERY and the low battery indicator will be displayed on the handset screen. When fully charged, the handset battery provides approximately three and a half hours of talk time or three and a half days of standby time.

• If the handset will

not be used for a

long period of time,

remove the battery

to prevent possible

leakage.

Getting started

1.Insert the plug of the battery as indicated. Make sure it is plugged securely and matches the color-coded label inside the battery compartment.

2.Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.

3.Align the bat ter y compartment cover flat against the battery compartment, then slide it upwards until it clicks into place.

4.Charge the handset by placing it in the telephone base and CHARGING... will be displayed on the handset screen.

• To purchase a

replacement battery,

visit our website at

www.vtechphones.

com or call

1 (800) 595-9511. In

Canada, go to www.

vtechcanada.com

or call 1 (800) 267-

7377.

THIS SIDE UP	Battery Pack	SIDE3.6V 300mAhUP Ni-Cd	ARNING: DO NOT BURN OR	PUNCTURE BATTERIES	MADE IN CHINA
		THIS

www.vtechphones.com

Image 7

Contents User’s manual Congratulations Table of contents Iii Telephone base Parts checklistHandset Power adapter Cover Battery Telephone baseDSL filter not included for DSL users Telephone line cord Telephone base installationBattery installation and charging Wall mounting Press to store a programming option or a directory entry Press to scroll down while in programming modePress to scroll up while in programming mode Handset layoutPress to page the handset Telephone base layoutDate and time Event of a power failure, the time may need to be resetRinger Ringer volumeHome area code Dial modeLanguage Clear voicemail End calls VolumeMake calls Answer callsTemporary tone dialing Call waitingFind handset RedialStore a directory entry DirectoryCharacter chart Review the directory Edit a directory entry Delete a directory entry Dial a number from the directory Copy a directory entry into speed dialStore a speed dial entry Speed dialCursor appears at the end of the name. Use the dial pad Edit a speed dial entryDial a speed dial number Delete a speed dial entryReassign speed dial locations About caller ID Call log Make a call log entry ready to dial Review the call logDial a call log number Save a call log entry to the directory Delete an entry Delete from the call logCaller is blocking the telephone number information Call log display screen messagesCaller is blocking the name and number information Handset display screen messages Battery Important safety instructions Telephone base for 16 hours TroubleshootingMy telephone does not Work at all Handset to the telephone base after useNot accept charge Telephone base and charge for 16 hoursTelephone company Place Incoming callCannot dial out First, try all the above suggestions See Dial mode on page 9 to set the dial typeCharges may apply When I am usingMy calls cut in and out Apart from each other, or use a different surge protectorHear other calls when Using the telephoneKeys or buttons work Caller ID during call ID serviceSystem does not Receive caller ID, or CompanyMy cordless handset Caller ID entries do notTo dial Numbers before dialing or saving the telephone numberCommon cure for Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsRbrc seal Technical specifications Index Appendix 91-001545-050-100