VTech CS2111-11, CS2112 user manual Common cure for, Place

Page 47

Troubleshooting

Problem

Suggestion

 

 

Common cure for

• If the unit is not responding normally, try putting the handset in the telephone base. If it does not respond,

electronic equipment

try the following (in the order listed):

 

• Disconnect the power to the telephone base.

 

• Disconnect the battery on the handset.

 

• Wait a few minutes before connecting the power to the telephone base.

 

Re-install the battery and place the handset in the telephone base.

 

• Wait for the handset to synchronize with the telephone base. Allow up to one minute for this to take

 

place.

 

 

www.vtechphones.com

43

Appendix

Image 47
Contents User’s manual Congratulations Table of contents Iii Telephone base Parts checklistHandset Power adapter Cover Battery Telephone baseDSL filter not included for DSL users Telephone line cord Telephone base installationBattery installation and charging Wall mounting Press to store a programming option or a directory entry Press to scroll down while in programming modePress to scroll up while in programming mode Handset layoutPress to page the handset Telephone base layoutDate and time Event of a power failure, the time may need to be resetRinger Ringer volumeHome area code Dial modeLanguage Clear voicemail End calls VolumeMake calls Answer callsTemporary tone dialing Call waitingFind handset RedialStore a directory entry DirectoryCharacter chart Review the directory Edit a directory entry Delete a directory entry Dial a number from the directory Copy a directory entry into speed dialStore a speed dial entry Speed dialCursor appears at the end of the name. Use the dial pad Edit a speed dial entryDial a speed dial number Delete a speed dial entryReassign speed dial locations About caller ID Call log Make a call log entry ready to dial Review the call logDial a call log number Save a call log entry to the directory Delete an entry Delete from the call logCaller is blocking the name and number information Call log display screen messagesCaller is blocking the telephone number information Handset display screen messages Battery Important safety instructions Telephone base for 16 hours TroubleshootingMy telephone does not Work at all Handset to the telephone base after useTelephone company Telephone base and charge for 16 hoursNot accept charge Place Incoming callCannot dial out First, try all the above suggestions See Dial mode on page 9 to set the dial typeCharges may apply When I am usingMy calls cut in and out Apart from each other, or use a different surge protectorKeys or buttons work Using the telephoneHear other calls when Caller ID during call ID serviceSystem does not Receive caller ID, or CompanyMy cordless handset Caller ID entries do notTo dial Numbers before dialing or saving the telephone numberCommon cure for Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsRbrc seal Technical specifications Index Appendix 91-001545-050-100