C. Crane A-66 manual Configuration Tools, Update Tools

GENERAL INFORMATION Optipay™CC Section1

If it is desirable to test all functions and not just the MDB functions, an additional G- 55.0348 RJ-45 PC plug adaptor is available from JCM, allowing you to connect the Coin Changer directly to the PC using the easily accessible 8-pin modular RJ-45 jack receptacle located on the top right side of the device.

Configuration Tools

In order to react as quickly as possible to new false coins in the workshop or on site, and enable indi- vidual adjustments, the coin changer can be con- nected to a:

•JCM Programming Station consisting of:

–WinEMP© configuration and diagnostics software which includes the card reader and chip card

–Tester G-19.0641

•JCM Palm Pilot®, and applications PalmEMP© and PalmA66© for a Palm Pilot® handheld

Chapter 11 "Configuration" explains which of the preceding configuration tools can be used to set the different Coin Changer parameters.

Update Tools

The Coin Changer’s integrated Coin Validator is equipped with microprocessor circuitry that con- tains Flash Memory. This allows quick updates of the Coin Validator’s operating software without complications. In order to load new operating soft- ware into the Coin Validator, one of the following three alternatives is required:

•a JCM PC Update Station consisting of:

–WinFlash© software

–Tester G-19.0641

–Programming adapter G-19.0646

•a JCM Flash Prommer G-55.0350 or

•JCM Palm "PalmFlash©" application for a Palm Pilot® handheld and a Flash Adapter

5900335 © 2005 JCM-American Corporation

1 - 3