C. Crane A-66 manual Enabling the Bill Recycler Select Tab on

PALM PILOT® USAGE Optipay™CC Section12

c). Float-up function warning (See Figure 12- 8).

If “Float up function on” is enabled and the level settings are not configured (i.e., set to zero [0]), the tube float level will only fill to the 50% sensor level.

Figure 12-8Float up Selection Warning

7.Setting Coin Changer “Security Stock” quantities.

a). Configure the “Security Stock” for each

tube by using the drop down menu’s triangular “up” and “down”arrows to set the desired value (See Figure 12-9 a).

a

c b

Figure 12-9Security Stock Mode

b). Click (See Figure 12-9 b) to program the Coin Changer or Cancel (See Figure 12-9 c) to return to the mode menu.

NOTE: A “Security Stock” level of three

(3)coins is recommended to prevent “coin bounce” and possible stacking issues in the Coin Changer tubes.

8. Configuring Changer tube “Coin Sorting”.

a). Select from the

mode menu.

b). The screen shows the current tube configuration (See Figure 12-10).

c). To change the tube configuration, select

(b)and then select from the

available payout combinations listed.

d). Click OK (c) to select or

e). to reset to Step “b” and then

f). to program the Coin Changer.

b	e
	d

c

Figure 12-10Coin Sorting Mode

9. Enabling the Bill Recycler.

a). Select the	tab on the
	menu screen and then check the

5 Recycler active tick box to enable the RC-10 recycling unit (See Figure 12-11). The recycle value will be set by the Coin Changer’s software.

5900335 © 2005 JCM-American Corporation

1 2 - 3