C. Crane A-66 manual Changer Diagnostics, 18Conversion Setting Mode

PALM PILOT® USAGE Optipay™CC Section12

ab

c

Figure 12-18Conversion Setting Mode

4. Currency conversion settings

a). Select the Service tab on the main menu screen (See Figure 12-18 a); then

b). Select (See Figure 12-

18 b) to view the screen.

c). Set the required coin base and conversion rate values. In addition, the appropriate coin channel parameters must also be set.

NOTE: Currency conversion can only be set if multiple currencies are programmed into the Coin Changer.

e). Select Send when finished program- ming (See Figure 12-18 c).

Changer Diagnostics

1.Select Diagnostics from the main menu screen (See Figure 12-19 a-b).

b

a

c

Figure 12-19Diagnostics Mode

a). The menu functions available (See Figure 12-19 b) are as follows:

•Software: – Current software version number

•EMP: – Changer self test

•Sorting: – Sorting gate test

•Tube sensors: – Self test

•Payout module: – Self test

•Inhibit switches – Current switch positions graphic.

b). Select (See Figure 12-19 c) to

access the fault description page and review the fault status if any.

2. To view the changer statistical meters: a). Click on the menu bar and then

b). Select from one of the three available Meter lists (i.e., Error list , Statistic counter 1 or Statistic counter 2 [See Figure 12-20 a]).

b

a

d c

Figure 12-20Error List Mode

c). The “Error List” reveals the

menu screen (See Figure 12-20 b) that dis- plays an error “Counter”, error “Code” list and 10 sensor type failure totals.

d). “Statistic counter 1” (See Figure 12-20 c)

displays the page 1 listing of the coins accepted relative to the coin channel.

e). “Statistic counter 2” (See Figure 12-20 d) displays the page 2 listing of the total coins accepted, paid out, and rejected. It also shows the total transactions for each coin tube.

5900335 © 2005 JCM-American Corporation

1 2 - 6