Panasonic KX-TG7341NZ Registering a unit, Selecting area codes to be deleted automatically

Programming

Selecting area codes to be deleted automatically

In some situations, phone numbers stored automatically in the caller list (page 29) will include area codes. If you do not want to dial the area codes when making calls from the caller list, you can store the area codes which you want the unit to delete automatically.

Example: You have stored the area code “09”. If you make a call from the caller list to the phone number “09-456- 7890”, the unit dials “456-7890”.

1K(middle soft key)

2{V}/{^}: “Base Unit Setup” i

M

3{V}/{^}: “Area Code” i M

4Enter an area code (5 digits max.). i Mi {ih}

Note:

L The use of this feature can prevent a National Call from being dialled. E.g., in the case of the South Island, the “03” will be omitted and will therefore prevent a National Call to other areas of the South Island.

Changing the base unit PIN (Personal Identification Number)

Important:

L If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, contact your nearest Panasonic service centre.

1K(middle soft key)

2{V}/{^}: “Base Unit Setup” i

M

3{V}/{^}: “Base Unit PIN” i

M

4Enter the current 4-digit base unit PIN (default: “0000”).

5Enter the new 4-digit base unit PIN. i Mi {ih}

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the base unit.

Important:

L The additional handset model recommended for use with this unit is noted on page 4. If another handset model is used, certain operations (handset settings, base unit settings, etc.) may not be available.

Registering a handset to the base unit

The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, w flashes even when the handset is near the base unit), re- register the handset.

1Handset:

K(middle soft key)

2{V}/{^}: “Handset Setup” i

M

3{V}/{^}: “Register H.set” i

M

4Base unit:

Press and hold {x} for about 5 seconds, until the registration tone sounds.

L If all registered handsets start ringing, press the same button to stop. Then repeat this step.

26