Panasonic KX-TG6542BX, KX-TG6541BX Error messages, Display message Cause/solution

Page 43

TG654xBX(e).book Page 43 Tuesday, June 28, 2011 10:16 AM

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message

Cause/solution

Base no power

L The handset has lost communication with the

or

base unit. Move closer to the base unit and try

again.

No link. Re-connect

L Unplug the base unit’s AC adaptor to reset the

unit. Reconnect the adaptor and try again.

base AC adaptor.

L The handset’s registration may have been

 

canceled. Re-register the handset (page 48).

Busy

L The called unit is in use.

 

L Other units are in use and the system is busy.

 

Try again later.

 

L The handset you are using is too far from the

 

base unit. Move closer and try again.

Call phone company for

L You have not stored the voice mail access

your access #

number. Store the number (page 38).

Check tel line

L The supplied telephone line cord has not been

 

connected yet or not connected properly.

 

Check the connections (page 8).

Error!!

L Recording was too short. Try again.

Invalid

L There is no handset registered to the base

 

unit matching the handset number you

 

entered.

 

L The handset is not registered to the base unit.

 

Register the handset (page 48).

Requires subscription

L You must subscribe to a Caller ID service.

to Caller ID.

Once you receive caller information after

 

subscribing to a Caller ID service, this

 

message will not be displayed.

Use rechargeable

L A wrong type of battery such as Alkaline or

battery.

Manganese was inserted. Use only the

 

rechargeable Ni-MH batteries noted on page

 

4, 6.

43

Image 43
Contents Before initial use, see Getting Started on Important Information Caller ID ServiceVoice Mail Service IntroductionModel composition Accessory informationSupplied accessories Accessory item/Part number Quantity KX-TG6541 KX-TG6542Accessory item Order number Additional/replacement accessoriesFor your safety Important safety instructions Other information Connections Setting upBattery installation Battery chargeOperation Operating time Intelligent eco modeDuring a power failure Battery level IconOFF Flash Call Wait ControlsHandset Base unitDisplay Belt clipDialing mode Initial settingsDate and time IPAUSE Using the base unitOFF Pause for PBX/long distance service users Erasing a number in the redial listAnswering calls Useful features during a callUsing the handset Adjusting the base unit ringer volumeFor call waiting or Call Waiting Caller ID service usersRotary/pulse service users FlashHandset clarity booster Privacy modeCall share Adding entries PhonebookGroups Select Finding and calling a phonebook entryEditing entries Erasing entriesMenu Chain dialMain menu Sub-menu Programmable settingsProgramming by scrolling through the display menus MenuStore VM access#*1 Feature Code Setting Programming using the direct commandsFor the answering system Feature Code Setting Min Greeting only Remote code Save AlarmNight mode Special programmingCall block Caller ID Changing the handset nameSubscribers only Save iOFF To erase a number To edit a numberMissed calls Using Caller ID serviceCaller ID features Talking Caller IDGroup ringer tone for Caller listViewing the caller list Calling backErasing all caller information Storing an area code to be deleted automaticallyEditing a caller’s phone number before calling back Erasing selected caller informationCall screening Answering systemTurning the answering system on/off Memory capacity including your greeting messageGreeting message Listening to messages using the base unitPause Listening to messages using the handsetErasing all messages Operating the answering systemRemote operation Voice memoVoice guidance Remote commandsTurning on the answering system remotely Selecting Greeting only Answering system settingsNumber of rings before the unit answers a call Caller’s recording timeMessage alert Listening to voice mail messages Voice mail serviceStoring the voice mail VM access number To erase the voice mail access numberTG654xBXe.book Page 39 Tuesday, June 28, 2011 1016 AM Answering an intercom call IntercomHandset locator Making an intercom callAnswering a transferred call Handset To establish a conference call Press ConfTo stand on a desk Wall mountingCharger HookDisplay message Cause/solution Error messagesGeneral use Problem Cause/solution TroubleshootingBattery recharge Problem Cause/solution Making/answering calls, intercom Problem Cause/solutionCaller ID/Talking Caller ID Problem Cause/solution Liquid damage Problem Cause/solution Answering system Problem Cause/solutionDeregistering a handset Registering a handset to the base unit HandsetIndex TG654xBXe.book Page 50 Tuesday, June 28, 2011 1016 AM TG654xBXe.book Page 51 Tuesday, June 28, 2011 1016 AM For your future reference PNQX5059ZA TC0711MG0Attach your purchase receipt here Copyright