Vertex Standard FTM-10R manual Programming a Member List

MESSAGE FEATURE

PROGRAMMING A MEMBER LIST

(Requires all members set the same member list (includes own ID) into the same member box in the same order.)

It is possible to register a maximum of 20 persons, in order to identify the sender. When you receive a message transfer, you can know who sent the message by the ID in the regis- ter. In addition, your ID can be sent to the members when you transmit any messages to them.

If all the members share the register information (ID), the message sender ID will be shown on the display when receiving the message.

Even if no IDs are registered, the function can work. In this case “MEMBER 1” though “MEMBER 20” will be displayed, when receiving a message.

We recommend that you use your call sign for the member list.

1.Press and hold the [VOL/SEL] key for one second to activate the Menu mode.

When the display indicates the Clock, Stop Watch Timer, or Temperature, press the [VOL/SEL] key to change to the VFO or memory mode, then perform the above step.

2.	Rotate the DIAL knob to select Menu Item “F16 ID LIST”.
3.	Press the	key to enable selection of this Menu Item.
4.	Rotate the DIAL knob to select the desired member box (1
	~ 20) into which you wish to store a member ID. The LCD
	will display the previously stored member ID.
5.	Press and hold the		key for one second.
	Press the PTT key to clear the previously stored message,
	if desired.
						Number of Member box
6.	Rotate the DIAL knob to select the first character of the
	personal ID you wish to store, and then press the				key
	briefly to save the first character of the personal ID and
	move on to the next place.
7.	Repeat previous step to complete the personal ID (up to 8
	characters). If you make a mistake, press the			key to

move back to the incorrect character, then re-enter the cor- rect character.

Press the PTT key to delete all data after the cursor that may have been previously stored erroneously.

8.When the personal ID entry is complete, press and hold in the key for one second. If you decide to cancel programming a message, press the [VOL/SEL] key, exit to normal operation.

9.If you wish to store another personal ID, repeat steps 4 through 8 above.

10.Press the [VOL/SEL] key to save the new setting and exit to normal operation.

FTM-10R OPERATING MANUAL 47