MESSAGE FEATURE
When the Club Channel monitor feature is activated, steps 1 and 2 above are not necessary.
3.Press the top panel 
or 
key to select the message you wish to send.
4.Press the top panel 
key to transmit the selected message on the Club channel fre- quency.
The “TXM” notation will appear on the display, and the message will be transmitted. It takes approximately 8 sec- onds to transmit the message.
When the message transmission is completed, the TX/BUSY indicator glows white for one second.
Receiving a Message
1.To receive a message, press the front panel 
or 
key to recall the Club channel or activate the Club Channel monitor feature (see page 44).
2.When you receive a message: a beep sounds, the TX/BUSY indicator blinks blue, and [“Message” from “sending station’s ID”] scrolls on the display.
Press the 
, 
, or 
key to clear the received message, and wait for a new mes- sage.
CLONING
You can transfer messages or all data stored in one
Note: The clone function is realized only by using the Club Channel frequency of 440 MHz amateur band. Recall and monitor the frequency of the Club Channel. If the channel is busy (some person is using the frequency and any signal is heard), the message clone function will not work correctly. In this case, change the Club Channel fre- quency. See page 52 for details.
Preparations (Source Transceiver)
1. Turn the transceiver off.
2. Press and hold the PTT key while turning the power on again.
The “TX CLONE” notation and the Club Channel frequency appear on the display alternately.
Preparations (Destination Transceiver)
1. Turn the transceiver off.
2. Press and hold the [VOL/SEL] key while turning the power on again.
3. Rotate the DIAL knob to select the “SF1 COPY ALL”.
50 |