Vertex Standard FTM-10R manual Scanning Band, SCAN-RESUME Mode

MISCELLANEOUS SETTING

SCANNING BAND

By default, the FTM-10Rconsiders the 144 MHz Amateur Band and 430 MHz Amateur Band to be independent bands while the scanner is activated. You may change scanner operation so that both the 144 MHz Amateur Band and the 430 MHz Amateur Band are scanned as one band.

1.Press and hold the [VOL/SEL] key for one second to activate the Menu mode.

2.Rotate the DIAL knob to select Menu Item “F30 SCN CVRG”.

3.Press the key to enable selection of this Menu Item.

4.Rotate the DIAL knob to select the desire mode.

IN BAND: The FTM-10Rconsiders the 144 MHz Amateur Band and 430 MHz Ama- teur Band to be an independent band and scans these when the scan mode is engaged. Activate the scanner on the 144 MHz Amateur Band only (or 430 MHz Amateur Band only).

HAM BAND: The FTM-10Rconsiders the 144 MHz Amateur Band and 430 MHz Ama- teur Band to be one band and scans it when the scan mode is engaged. Activate the scanner across the 144 MHz Amateur Band and 430 MHz Amateur Band.

5.Press the [VOL/SEL] key to save the new setting and exit to normal operation.

SCAN-RESUME MODE

Three scan-resume modes are available on the FTM-10R:

BUSY:In this mode, the scanner will remain halted for as long as there is car- rier present on the channel. After the carrier drops at the end of the other station's transmission, scanning will resume.

HOLD: In this mode, the scanner will halt on a signal it encounters. It will not restart automatically; you must manually re-initiate scanning if you wish to resume.

TIME 3S/5S/10S: In these modes, the scanner will halt for the selected resume time, after which scanning will resume (whether or not the other station is still transmitting).

The default scan-stop mode is “BUSY.” To change the scan-resume mode, use the following procedure:

1.Press and hold the [VOL/SEL] key for one second to activate the Menu mode.

2.Rotate the DIAL knob to select Menu Item “F32 SCN MODE”.

3.Press the key to enable selection of this Menu Item.

4.Rotate the DIAL knob to set the desired scan-resume mode.

5.Press the [VOL/SEL] key to save the new setting and exit to normal operation.

80 FTM-10R OPERATING MANUAL