English
AZ 1560 /00 page 14
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
PROBLEM
–POSSIBLE CAUSE
• REMEDY
No sound/power
–VOLUME not adjusted
• Adjust the VOLUME
–Headphones connected
• Disconnect headphones
–Mains lead not securely connected
• Connect AC mains lead properly
Severe radio hum or noise
–Electrical interference: set too close to TV, VCR or computer
• Increase the distance
Poor radio reception
–Weak radio signal
•FM: Direct the FM telescopic aerial for optimum reception
indication
–CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
–Laser lens steamed up
• Wait until lens has cleared
The CD skips tracks
–CD damaged or dirty
• Replace or clean CD
–SHUFFLE or PROGRAM is active
• Switch off SHUFFLE / PROGRAM
Poor cassette sound quality
–Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
–Use of incompatible cassette types (METAL or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
–Cassette tab(s) may be broken
•Apply a piece of adhesive tape over the missing tab space.
indication
–
• Use a finalised
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
14