MAINTENANCE | ||
|
|
|
MAINTENANCE
Safety Precautions
WARNING
ELECTRIC SHOCK can kill.
•Do not touch electrically live parts such as output terminals or internal wiring.
•When inching with gun trigger, electrode and drive mechanism are “hot” to work and ground and could remain energized several seconds after the gun trigger is released.
•Turn OFF input power at welding power source before installation or changing drive roll and/or guide tubes.
•Welding power source must be connected to system ground per the National Electrical Code or any applicable local codes.
•Only qualified personnel should perform this installation.
Observe all additional Safety Guidelines detailed throughout this manual.
Routine Maintenance
Drive Rolls and Guide Tubes
After feeding every coil of wire, inspect the drive roll section. Clean it as necessary. Do not use a solvent for cleaning the idle roll because it may wash the lubricant out of the bearing. The driver roll and guide tubes are stamped with the wire sizes they will feed. If a wire size other than that stamped on the roll(s) is to be used, the roll(s) and guide tubes must be changed.
The drive rolls for .035” (0.9mm) through .052” (1.3mm) cored electrode and 1/16” (1.6mm) through 3/32” (2.4mm) electrode have a double set of teeth so they can be reversed for additional life. Drive rolls for
.023" (0.6 mm) through .052" (1.3 mm) solid elec- trodes have no teeth, but use two grooves so they also can be reversed for additional life.
See “Procedure to Install Drive Roll and Guide Tubes” in the INSTALLATION section for roll changing instructions.
Wire Reel Mounting -
No routine maintenance required. Do not lubricate 2” (51mm) spindle.
Avoiding Wire Feeding Problems
Wire feeding problems can be avoided by observing the following gun handling and feeder set up proce- dures:
•Do not kink or pull cable around sharp corners.
•Keep the electrode cable as straight as possible when welding or loading electrode through cable.
•Do not allow dolly wheels or trucks to run over cables.
•Keep cable clean by following maintenance instructions.
•Use only clean,
•Replace contact tip when the arc starts to become unstable or the contact tip end is fused or deformed.
•Do not use excessive wire spindle brake settings.
•Use proper drive rolls, guide tubes and drive roll pressure settings.
Periodic Maintenance
Wire Drive Motor and Gearbox
Every year inspect the gearbox and coat the gear teeth with a
Every six months check the motor brushes. Replace them if they are less than 1/4” long.
Gun and Cable Maintenance
See appropriate Operatorʼs Manual.
Procedure for Removing Feedplate from Wire Feeder
1)Loosen the clamping collar screw using a 3/16" Allen wrench. The clamping collar screw is accessed from the bottom of the feedplate. It is the screw which is perpendicular to the feeding direction.
2)Loosen the retaining screw, which is also accessed from bottom of feeder, using a 3/16" Allen wrench. Continue to loosen the screw until the feedplate can be easily pulled off of the wire feeder.