Options / Accessories

ACCESSORIES

The following field installed Kits and accessories may be used dependingon the application:

K936 Control Cables

At least one of the following control cables is needed to connect the TIG Module to the power source. Four different cables are available. The proper choice of cable depends on the power source being used. See the installation section to choose the proper control cable. The control cable carries one or more of the following circuits between the TIG Module and the power source: Input power, remote control signals, contactor control signals, and ground.

K936-19-Socket (at the TIG Module) to 14-pin (at the power source) (Contains circuits 2, 4, 31, 32, 75, 76, 77 and ground)

K936-39-Socket to a grounded 115V plug and a 6-pin MS-connector (Contains circuits 31, 32, 75, 76, 77 and ground)

K936-49-Socket to a grounded 115V plug (Contains circuits 31, 32 and ground.)

K937 Control Cables Extensions

Control cable extensions are available in 22 and 45 foot engths. These allow the TIG Module to be operated at distances up to 200 feet from the power source. The extensions connect between the standard control cable and the TIG Module.

K937-2222 foot extension cable, 9-Socket to 9-pin

K937-4545 foot extension cable, 9-Socket to 9-pin

K938-1 Contactor Kit

This field installed kit must be installed in the TIG Module whenever it is used with a power source which does not have a built-in contactor for constant current (stick/TIG) welding. See the list of compatible power sources to see which applications require the Contactor Kit.

K844-1 Water Valve Kit

A field installed kit which contains one water valve for mounting inside the TIG Module. The water valve is controlled by the same preflow and afterflow timers as the gas valve.

Other Compatible Lincoln Accessories:

K963 Hand Amptrol

K870 Foot Amptrol

K814 Arc Start Switch

All Magnum TIG torches and accessories

Compatible Equipment

The TIG Module can be used with the following Lincoln power sources:

Ranger 81

Ranger 9

Ranger 101

Ranger 10-LX1

DC-250

DC-400

DC-600

DC-650Pro/DC-750

R3R-300/400/500,

including “I” versions1

Idealarc 250 AC/DC1

Weldanpower 1501

Weldanpower 150 AC/DC1

Weldanpower G80001

SA 250 Perkins1

SAE 350 Deutz1

SAE 4001

Classic I1,2

Classic II1

Classic III & IIID1

1Requires the K938-1 Contactor Kit in the TIG Module 2Requires a source of 115VAC power

For installation of field installed accessories see the

INSTALLATION SECTION.

K939-1 Docking Kit

The Docking Kit provides a means to “dock” the TIG Module on top of a flat-roofed power source, or any other flat surface measuring at least 10 X 15 inches (255 X 381 mm). It includes a latch and provisions for a user-supplied padlock to lock the TIG Module in place.

TIG MODULE

– 31 –