Lincoln Electric IM528-B manual Ranger 10 / TIG Module Connection Diagram

FIGURE 4: RANGER 10 / TIG MODULE CONNECTION DIAGRAM

WARNING

Do not operate with panels open.

Disconnect NEGATIVE (-) BATTERY LEAD before servicing.

Do not touch electrically live parts.

REGULATOR

FLOWMETER

Keep guards in place.

Keep away from moving parts.

Only qualified personnel should install,use or service this equipment.

– 12 –

TIG

ARGON GAS

TO GAS

CYLINDER

INPUT

FITTING

A T12246 BYPASS CAPACITOR ASBLY. MUST BE INSTALLED IN THE RANGER 10 TO PROTECT THE RANGER 10 FROM DAMAGE.

WELDING CABLES MUST BE PROPERLY SIZED FOR THE CURRENT AND DUTY CYCLE OF APPLICATION.

	O
	HF			CURRENT
POWER	HIGH FREQUENCY	AFTERFLOW	CURRENT CONTROL	CONTROL
				SWITCH
LINCOLN
ELECTRIC				WARNING

E F

K870 FOOT AMPTROL

-OR-

K963 HAND AMPTROL

-OR-

K814 ARC START SWITCH

INSTALLATION

MODULE

11/96

M17533

NOTE: This diagram is for reference only. It was accurate at the time of printing , however Lincoln Electric reserves the right to make improvements and modifications as necessary, if you supect this information to be inaccurate, write to the Service Department for a replacement. Give the equipment code number..