TOC
TOC
INSTALLATION | |||
|
| ||
CONNECTION FOR AIR/CARBON ARC | 3. If necessary, disconnect all wire feeder control | ||
CUTTING OPERATION |
| cable connections from the | |
|
| strip. |
|
Return to Section
Return to Master
WARNING
THE OUTPUT TERMINALS ARE ENERGIZED AT ALL TIMES WHEN THE IDEALARC
____________________________________________________
4.Remove the leads from the unit by pulling them through and out of the strain relief box connector
(s).
5.Connect a jumper wire from terminal #2 to termi- nal #4 on the terminal strip.
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
1. Set ON/OFF PUSH BUTTON to OFF. | 6. Set the Welding Mode Switch to the CV(I) position | |
for air/carbon arc cutting. | ||
|
2.Locate and open the access door on the Front Case Assembly.
IDEALARC