Hitachi C 6DC2 Assembly and Operation, Applications, Removal and Installation Method of Battery

English

ASSEMBLY AND OPERATION

APPLICATIONS

◯Cutting Various types of wood.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Handle		◯ How to install the battery.
		Align the battery with the groove in tool
		handle and install it into place.
	Push	Always insert it all the way until it locks in
		place with a little click, If not, it may
Insert	Latch	accidentally fall out of the tool, causing injury
		to you or someone around you. (Fig. 5)
		◯ How to remove the battery.
	Battery	Withdraw battery from the tool handle while
		pressing the latches on both sides of the
	Pull out
		battery. (Fig. 5)
	Fig. 5

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.

◯The power source voltage is stated on the nameplate.

◯The cord is not damaged.

WARNING: Do not charge at voltage higher than indicated on the nameplate.

If charged at voltage higher than indicated on the nameplate, the

charger will burn out. Battery

	1. Insert the plug of battery charger into
	the receptacle.
	When the plug of battery charger has been
Pilot lamp	inserted into the receptacle, pilot lamp will
	blink in red. (At 1-second intervals)
	WARNING: Do not use the electrical
	cord if damaged. Have it
	repaired immediately.
14	Fig. 6