Hitachi C 6DC2 instruction manual Dismounting the saw blade, Mounting the Saw Blade Fig

English

1. Dismounting the saw blade

(1)Set the cutting volume at maximum, and place the Circular Saw as shown in Fig. 18.

(2)Depress the lock lever, lock the spindle, and remove the hexagonal-head bolt and washer(B1) with the box wrench.

(3)While holding the safety cover lever to keep the safety cover fully retracted into the saw cover, remove the saw blade. (Fig. 19)

2. Mounting the Saw Blade (Fig. 20)

WARNING:

If the bolt is worked using other tools than the provided box wrench, excessive tightening and insufficient tightening may take place, resulting in injury.

◯Take procedures here that are contrary to the detaching procedures.

Box Wrench

	Loosen
Tighten	Lock Lever

Fig. 18

NOTE:

⬤ Thoroughly remove any sawdust which

has accumulated on the spindle, bolt and

washers.

⬤ To assure proper rotation direction of the

Safety Cover Lever

Saw Cover

saw blade, the arrow direction on the saw

blade must coincide with the arrow

direction on the saw cover.

⬤ Using the fingers, tighten the hexagonal-

head bolt retaining the saw blade as much

as possible. Then depress the lock lever,

lock the spindle, and thoroughly tighten

the hexagonal-head bolt.

CAUTION:

After mounting the saw blade, reconfirm that the lock lever is firmly secured in the prescribed position.

	Fig. 19
Hexagonal-Head Bolt			Washer (A1)
		Ring		Spindle

Washer (B1)

Concave

Saw Blade

Fig. 20

23