Grizzly G0504 Connecting to Dust, Power Source, To connect the resaw to a dust collector

Page 24

Connecting to Dust		Connecting to
Collector		Power Source

To be effective, the dust collection system that you connect to the resaw must be able draw a combined total of at least 1000 CFM at the dust ports. Note—This number is an approximation and has been provided for estimation purposes only.

To connect the resaw to a dust collector:

1.Attach two 4" dust hoses to the dust ports as shown in Figure 20, and be sure to tighten the hose clamp to ensure a snug fit.

Figure 20. Dust hose connected to dust port.

If you have performed all of the previous set up instructions, the resaw can now be connected to the power source by a qualified electrician.

-22-	G0504 16" Horizontal Resaw Bandsaw

Image 24

Contents Model G0504 Horizontal Resaw Bandsaw Page Table of Contents Service Adjustments PartsGeneral Information CommentaryMachine Data Sheet G0504 16 Horizontal Resaw Bandsaw G0504 16 Horizontal Resaw Bandsaw Additional Safety Instructions for Bandsaws Additional Safety Instructions for Hydraulics Phase Power Circuit RequirementsGrounding Converting to Inside of electrical boxMain motor 440V wiring Machine Features Main FeaturesPage Memory Preset Keys A, B, C, D-Allows Control PanelSET UP About this SectionPiece Inventory UnpackingHardware Recognition Chart Clean Up Site Considerations Removing Resaw from Crate Pallet Mounting Resaw to the FloorInstalling Tensioning Blade To install and tension the bladeAdjusting Blade Guides Always de-tension blade after useTo adjust the upper guide block Support Bearing To adjust the support bearingsConnecting to Dust Power SourceTo connect the resaw to a dust collector Power on switch Test RunOperation Safety Conveyor Controls OperationsTo operate the infeed conveyor Setting Blade Height Calibrating Digital DisplayTo set the blade height with the keypad To calibrate the digital displaySetting Memory Using Memory Button To store a height in the a memory preset keyTo use the stored memory preset in the a key To set the memory functionResawing To perform a resawing operationBlade Information Accessories H4959-Coolant DispenserH0580-Pneumatic Grease Gun H1300 H1298 G7984 H2347 H0736Maintenance CleaningMiscellaneous BeltsGrease Fittings Hydraulic System Minor Service Check the hydraulic fluid level dailyHydraulic System Major Service To inspect the hydraulic fluidTo clean the tank screen To clean the bottom of the tankTo fill the tank with new fluid Service Adjustments About ServiceAdjusting Lower Blade Guides Adjusting V-Belt Tension To adjust the tension for the hydraulic pump V-beltAdjusting Main Conveyor Table Replacing V-BeltsTo check the main conveyor table alignment Tracking Conveyors To set the conveyor trackingReplacing Conveyors To replace the conveyor beltsDisconnect the resaw from the power source Blade Tracking Wheel Alignment Screws Page Troubleshooting UnderpoweredSymptom Possible Cause Possible Solution Housing Parts PartsHousing Parts List DescriptionFrame Parts Frame Parts List Elevation Parts Elevation Parts List Blade Guide Parts Adjustment ROD Bracket Tensioning Wheel Parts Tensioning Wheel Parts List Drive Wheel Parts Hydraulic Pump Parts Main Conveyor Table Parts Main Conveyor Table Parts List Return Conveyor Table Parts Rear Hold Down Parts Front Hold Down Parts Front Hold Down Parts List Hydraulic System Parts Hydraulic System Parts List Connector 3/8H X 3/8HElectrical System Parts Electrical System Parts Electrical System Parts List Warranty and Returns Page Page Page