Woodstock W1811 manual Flat washers, =`li\*% Sliding table handle attached

N(/((('Jc`[`e^KXYc\JXn

)+% Remove the shipping brace from the sliding table
(=`^li\)/), then install the sliding table end cover	Shipping
over the fixed part of the sliding table end, as shown	Brace
in =`^li\)0, using the pre-mounted hardware.

=`^li\)/% Sliding table shipping brace.

	=`^li\)0% Sliding table end cover
	installed.
),% Attach the sliding table handle, as shown in =`^li\
*', with two premounted button head screws and		Button Head
flat washers.		Cap Screws

	=`^li\*'% Sliding table handle attached
		to end of sliding table.
)-%Thread two M5-.8 x 12 cap screws with 5mm lock
washers through the switch bracket and into the		Magnetic
sliding table base, and tighten the cap screws (see		Switch
=`^li\*().

=`^li\*(% Magnetic switch installed.

-23-

J<KLG