Woodstock W1811 Jc``eKXYc\GXiXcc\c`jd, +,—Jkfg, +% Tighten the two set screws in the stop nut

N(/((('Jc`[`e^KXYc\JXn

+,—Jkfg

(% DISCONNECT SAW FROM POWER!

)% Adjust the blade angle until it hits the 45° positive stop and check the blade angle with a 45° square.

—If the blade is not 45° to the table, loosen the two set screws that secure the 45˚ tilt stop nut shown in =`^li\0/%(This nut can also be accessed from the front of the saw by moving the sliding table all the way forward.)

*% Adjust the stop nut and recheck the blade tilt as many times as necessary until the blade is 45° to the table.

45° Tilt

Stop Nut

=`^li\0/% 45° Blade tilt stop nut.

J<IM@:<

+% Tighten the two set screws in the stop nut.

Jc`[`e^KXYc\GXiXcc\c`jd

The table is calibrated at the factory, but can be adjusted slightly if it is not parallel to the blade.

Besides the tools included with the saw, this procedure requires a felt tip pen, an adjustable square, and a set of feeler gauges or a dial indicator.

Efk\1Lj`e^X[`Xc`e[`ZXkfin`ccgifm`[\dlZ_dfi\

XZZliXk\i\jlckj%

KfX[aljkk_\jc`[`e^kXYc\gXiXcc\cn`k_k_\dX`eYcX[\# [fk_\j\jk\gj1

(% DISCONNECT SAW FROM POWER!

)% Move the blade tilt to 0˚ (blade 90˚ to table), and raise the main blade up to maximum height.

*% Mark the edge of the blade with a felt tip pen. This	9cX[\
will allow you to take your measurements from the
exact same place on the blade.	KXYc\
+% Using an adjustable square or a dial indicator, mea-			8 D`k\iJcfk
		9
sure the distance (A) between the miter slot and the
front of the blade, as shown in =`^li\00.
,% Rotate the blade 180° and slide the table with the
measuring device to position B.
	=`^li\00% Measuring gap between the
	table and the blade.

-56-