Woodstock W1811 manual Figure /,. Second cut to create a rabbet

N(/((('Jc`[`e^KXYc\JXn

Lj`e^XJkXe[Xi[9cX[\

When making rabbet cuts with a standard blade, use a ripping-type blade to reduce motor overloading and blade wear. Also, you will need to remove the blade guard/dust hood, but leave the riving knife installed, making sure that its height is slightly lower than the blade.

Efk\1Cutting rabbets with a standard saw blade DOES NOT require the use of a sacrificial fence.

The danger of kickback increases relative to the depth and width of a cut. Reduce the risk of kickback by making multiple passes to achieve the desired depth of cut. Failure to follow these warnings could result in serious personal injury.

KfdXb\XiXYY\kZlkn`k_XjkXe[Xi[YcX[\#[fk_\j\
jk\gj1		=\eZ\
1.	DISCONNECT THE SAW FROM POWER!	JXn9cX[\
2.	Clearly mark the width of the rabbet cut on the	Nfibg`\Z\
	workpiece.
	Efk\1 Include marks on the edge of the workpiece
	to clearly identify the intended cut while it is laying
	flat on the saw table.
3.	Raise the blade up to the desired depth of cut (depth

of rabbet channel desired). When cutting deep	rab		-
				Figure /+. Rabbet cutting with a standard
bets, take more than one pass to reduce the risk		of			blade.
kickback.

FG<I8K@FEJ

4.Adjust the fence so the blade is aligned with the inside of your rabbet channel as shown in Figure /+.

5.Reconnect the saw to the power source and turn the saw FE.

6.When the blade has reached full speed, perform a test cut with a scrap piece of wood.

7.If the cut is satisfactory, repeat the cut with the final workpiece.

8.Stand the workpiece on edge as shown in Figure /,.

9.Adjust the saw blade height to intersect with the first cut.

=\eZ\

Nfibg`\Z\

JXn9cX[\

Figure /,. Second cut to create a rabbet.

10.Perform the second cut to complete the rabbet.

-48-