Woodstock W1811 manual 8jj\dYcp J\klg, KfXjj\dYc\k\jc``ekXYc\jXn#fk\j\jk\gj1

N(/((('Jc`[`e^KXYc\JXn

8jj\dYcpJ\klg

J<KLG

Before shipping, the sliding table was installed on the machine and calibrated to the main table and blade. As such, be careful not to move any pre-installed nuts when installing the sliding table.

The sliding table and extension tables are heavy, so use a forklift or four strong helpers to lift the sliding table during installation.

KfXjj\dYc\k_\jc`[`e^kXYc\jXn#[fk_\j\jk\gj1

(. Place the sliding table on the cabinet.

). On each side of the sliding table, slide a T-stud down the center bottom T-slot until it is next to the mounting bracket.

*. Lift one side of the sliding table, position the T-stud over the hole in the mounting bracket, then lower the sliding table so the T-stud fits through the hole, as shown in =`^li\(*. Repeat on the other side.

+. Put a 12mm flat washer, 12mm lock washer and M12-

1.75hex nut on the bottom of each T-stud and tight- en the hex nut to secure the sliding table in place.

,. Install the small extension table with the two M10-

1.5x 25 cap screws, 10mm flat washers and 10mm lock washers (see =`^li\(+).

-%Thread one M8-1.25 hex nut halfway onto each of the M8-1.25 x 25 set screws, then install two of the set screws where shown in =`^li\(+, to act as lev- eling screws in a later step.

.% Install the large extension table with the three M10-

1.5x 25 cap screws, 10mm flat washers, and 10mm lock washers (see =`^li\(,).

/% Thread four M8-1.25 x 25 set screws with hex nuts where shown in =`^li\(,, to act as leveling set screws in a later step.

0% Level the top of the extension tables even with the top of the cast iron table.

Using a straightedge as a guide (=`^li\(-), adjust the leveling set screws to align the top of the exten- sion tables with the top of the cast iron table. Tighten the hex nuts on the leveling screws against the extension table to lock the screws when the tables are aligned.

-18-

T-Stud Inserted

Through Mounting

Bracket

=`^li\(*% T-stud inserted in mounting

bracket.

Mounting Cap Screws

Leveling Set Screws

=`^li\(+% Small extension table installed.

Mounting Cap Screws

Leveling Set Screws

=`^li\(,% Large extension table installed.

=`^li\(-%Extension wings mounted and

even with cast iron table.