Woodstock W1811 manual IfjjZlkk`e=lccJ`q\GXe\cj, IfjjZlkk`eJdXcc\iGXe\cj

N(/((('Jc`[`e^KXYc\JXn

:ifjjZlkk`e^=lccJ`q\GXe\cj

(% Install the crosscut fence in the forward mounting location shown in =`^li\., and lock it in place.

)% Check to make sure the fence is at 90˚. If necessary, adjust it as described in :Xc`YiXk`e^:ifjjZlk=\eZ\ 0'—Jkfgj on GX^\,/.

*% Set either flip stop to the desired width-of-cut. Extend the crosscut fence slide if the workpiece is more than 74".

+% Load the workpiece onto the table saw (=`^li\.)).

,% Once all the necessary safety precautions have been taken, perform the cutting operation.

Rear Mounting

Location

Forward Mounting

Location

=`^li\.,% Crosscut fence mounting

points.

:ifjjZlkk`e^JdXcc\iGXe\cj

(% Install the crosscut fence in the rear mounting points shown in =`^li\., and lock it in place.

)% Check to make sure the fence is at 90˚ and adjust it as described in :Xc`YiXk`e^:ifjjZlk=\eZ\0'— Jkfgj on GX^\,/if necessary.

*% Set either flip stop to the desired width-of-cut. Extend the crosscut fence slide if the workpiece is more than 74".

+% Load the workpiece onto the table saw (=`^li\.* %

,% Once all the necessary safety precautions have been taken, perform the cutting operation.

:ifjjZlkk`e^ Lj`e^ I`g =\eZ\ Xj X :lk$F]] >Xl^\

(% Install the crosscut fence in the rear mounting points shown in =`^li\., and lock it in place.

)% Check to make sure the fence is at 90˚ and adjust it as described in :Xc`YiXk`e^:ifjjZlk=\eZ\0'— Jkfgj on GX^\,/if necessary.

*% Position the rip fence for the desired width.

+% Load the workpiece onto the table saw (=`^li\.+).

,% Slide the leading end of the rip fence behind the front edge of the blade as shown in =`^li\.-.K_`j jk\g`jZi`k`ZXckfi\[lZ\k_\i`jbf]YcX[\Y`e[`e^ Xe[b`ZbYXZb%

-43-

	Rip Fence
Front Edge	Leading Edge
of Blade	of Rip Fence

Figure .-.Correct rip fence position when

using it as a cut-off gauge.

FG<I8K@FEJ