Woodstock W1811 manual `glkk`en`kI`g=\eZ, Slide the crosscut table out of the way, =`li\-0%

N(/((('Jc`[`e^KXYc\JXn

I`g:lkk`e^n`k_I`g=\eZ\

(% Slide the crosscut table out of the way.

)% Lock the sliding table into a stationary position (see =`^li\-/).

Efk\1K_\kXYc\n`ccfecpcfZb`egcXZ\n_\e`k`j Z\ek\i\[n`k_k_\jXnZXY`e\k%

*% Place the rip fence in the vertical position for larger workpieces, or in the horizontal position for angled cuts and for small workpieces (see =`^li\-0).

+% Slide the leading end of the rip fence so it is even with the center of the main saw blade as shown in =`^li\.'.

Efk\1K_`jk\Z_e`hl\Xccfnjk_\]`e`j_\[Zlk$f]] g`\Z\kfÈ]XccÉXnXp]ifdk_\YcX[\n_\ek_\Zlk$ k`e^fg\iXk`fe`jZfdgc\k\2i\[lZ`e^k_\gfjj`Y`c`kp f]b`ZbYXZb%

,% Tighten the lock handles (=`^li\.() to secure the rip fence against the base.

-%Pull up the lock lever to loosen the fence base on the rail, position the fence at the correct distance away from the blade (as needed for the cut), then push down the lock lever to lock the fence base in position.

.% Take all the necessary safety precautions, then make the cut as you would with a traditional table saw.

-41-

Table Lock

=`^li\-/%Sliding table lock.

Vertical

		Horizontal	FG<I8K@FEJ
=`^li\-0%	Rip fence positions.

Rip Fence

Figure .'. Rip fence even with center of blade (blade guard removed for clarity).

Lock

Handles

Lock

Lever

=`^li\.(% Rip fence micro-adjusting controls.