Woodstock W1811 manual 9cX\K`ckXc`YiXk`fe, JZfi`e9\ckI\gcXZ\d\ek, —Jkfg

N(/((('Jc`[`e^KXYc\JXn

JZfi`e^9\ckI\gcXZ\d\ek

(% DISCONNECT SAW FROM POWER!

)% Tilt the blade to 45˚ and lower it as far as it will go.

*% Remove the motor cabinet door.

+% Pull the tensioner away from the scoring belt (=`^li\ 0,) to relieve belt tension and remove the scoring belt from the pulleys.

Scoring Belt

Scoring Belt

Tensionser

Efk\1Kliek_\Y\ckj`[\nXpjkfjhl\\q\k_\]cXk gXikk_ifl^_k_\jdXcc^XgY\kn\\ek_\Yfkkfdglc$ c\pXe[k_\ZXjk`e^%

,% Put the new scoring belt on the pulleys as shown in =`^li\0-, and push the tensioner against the scor- ing belt to take up any slack.

-%Replace the motor cabinet door.

9cX[\K`ck:Xc`YiXk`fe

The blade tilt is calibrated at the factory, but can be recalibrated if it changes during the life of the machine. The 0° stop positions the blade square with the table.

=`^li\0,% Replacing the scoring motor

belt (table removed for clarity).

2EjaaZn$GdaaZg

2HXdg^c\7Zai

IZch^dcZg

BdidgEjaaZn

=`^li\0-%Scoring belt installation

configuration.

'—Jkfg

(% DISCONNECT SAW FROM POWER!

)% Move the blade tilt to 0° according to the gauge, and raise the main blade as far as it will go.

*% Use a machinist's square to check if the blade is square to the table.

—If the blade is not square to the table, loosen the two set screws that secure the 0˚ tilt stop nut shown in =`^li\0.%

+% Adjust the stop nut and recheck the blade tilt as many times as necessary until the blade is square to the table.

,% Tighten the two set screws in the stop nut.

-%Check the blade tilt pointer mechanism to ensure that it points to 0°.

—If the blade tilt pointer shows an incorrect tilt, adjust it by loosening the cap screws, rotating the pointer until it points to 0°, then tightening the cap screws.

-55-

0° Tilt

Stop Nut

=`^li\0.% Blade tilt stop nut (0°).

J<IM@:<