Woodstock W1811 manual Jklg

N(/((('Jc`[`e^KXYc\JXn

J<KLG

).% Thread the feet all the way into the bottom of the support legs. DO NOT remove the hex nuts pre- installed on the bottom of the feet, since they will be used after the legs are installed.

)/% Thread two M10-1.5 x 30 cap screws and 10mm lock washers through each support leg and part way into the T-slot plates for the legs, slide the T-slot plates into the both ends of the sliding table base, and tighten the mounting cap screws (see =`^li\*)).

)0% Adjust the feet downward so they press against the floor, then tighten the hex nuts up against the sup- port leg so the feet are locked in place.

*'% Open the cabinet door and remove the motor ship- ping brace shown in =`^li\**.

*(% Tilt the blade assembly to 0˚, then slide the slid- ing table forward all the way until you can open the lower blade guard cover and access the blade arbors.

9\]fi\gifZ\\[`e^n`k_k_\e\okjk\gj#n\ i\Zfdd\e[k_Xkpfln\Xi^cfm\jkfgifk\Zkpfli _Xe[jn_\e_Xe[c`e^Xe[`ejkXcc`e^k_\YcX[\%

*)% Insert the arbor lock tool into the hole shown in =`^li\*+, rotate the arbor until the arbor lock tool seats, then install the main blade, using the included arbor wrench to loosen and tighten the arbor nut (the arbor nut has left-hand threads and loosens clockwise). There MUST be an arbor flange between the blade and the arbor nut.

**% Insert the arbor lock tool into the hole shown in =`^li\*,, rotate the arbor until the arbor lock tool seats, then install the scoring blade, using the arbor wrench. There MUST be an arbor flange on both sides of the blade.

Support Leg

=`^li\*)% Support leg installed (1 of 2

shown).

=`^li\**% Motor shipping brace.

Arbor

Lock

Tool

=`^li\*+% Installing main blade.

Arbor

Lock

Tool

=`^li\*,% Installing scoring blade.

-24-