N(/((('Jc`[`e^KXYc\JXn
|
|
|
|
| |
|
|
|
|
| |
(use the feeler gauge if using the adjustable square). |
|
|
| Parallel |
|
Make note of the difference between the two mea- |
|
| Adjustment Screw |
| |
surements. |
|
|
|
|
|
|
|
|
|
| |
— If the gap is the same on both sides or the differ- |
|
|
|
|
|
ence is 0.004" or less, no adjustments to the table |
|
|
|
|
|
parallelism need to be made. |
|
|
|
|
|
— If the difference is greater than 0.004", then |
|
|
|
|
|
the sliding table parallelism must be adjusted. |
|
|
|
|
|
Proceed to Jk\g.. |
|
|
|
|
|
| Table Mounting |
|
| ||
|
|
| |||
.% Loosen the sliding table mounting nuts (see =`^li\ |
| Nuts |
| ||
|
|
|
|
| |
|
|
|
|
| |
('') at both mounting locations. |
|
|
|
|
|
|
|
|
|
| |
Figure (''. Table parallelism adjustment | |||||
|
| controls. | |||
/% At the side of the table that needs to move, loosen the hex nut on the parallel adjustment screw.
0% Slowly rotate the parallel adjustment screw (=`^li\ ('') as necessary to move the table. If you move the adjustment screw away from the table, then push the table against the screw before proceeding.
('% Tighten the hex nut on the parallel adjustment screw to secure it in place, and tighten the table mounting nuts.
((% Repeat Jk\gj+Æ- to ensure the table didn't move.
Jc`[`e^KXYc\8[aljkd\ek
EFK@:<
@] k_\ jc`[`e^ kXYc\ n`cc efk dfm\ ]Xi \efl^_ kf Y\Zfd\ gXiXcc\c# k_\ YcX[\ kilee`feje\\[kfY\j_`]k\[%:XccK\Z_ Jlggfik%
The sliding table features an adjustment bar with bolts that control how easily the sliding table moves across the base (see =`^li\('(). These adjustment bolts are factory set. They can only be accessed by removing the end covers from both ends of the sliding table base and sliding the plastic plate out of the way.
If the adjustment bolts do require adjustments, turning them counterclockwise increases pressure against the steel rails. This reduces table movement slop, which increases accuracy, but makes it harder to slide the table.
Turning the adjustment bolts clockwise decreases the pressure against the steel rails. This increases table move- ment slop, which reduces accuracy, but makes it easier to slide the table.
Adjusting this part of the sliding table correctly is a matter of
Adjustment
Bolt
=`^li\('(% Adjustment bolt access
location.