Location

5.Highlight the device and press ENTER. The Device Configuration menu will open. The device name will be reset to its default setting. Press EXIT repeatedly to return to the main display.

The Location menu allows you to select a configuration name that matches the location of the engine connected to your fuel flow sensor.

To change fuel flow location:

1.Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A menu will appear with five options: Bus Setup, Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.

2.Highlight BUS SETUP and press ENTER, which will open the Bus Configuration menu. A list of network devices will be at the top of the page.

3.Select the fuel flow you want to configure and press ENTER. The Device Configuration menu will appear.

4.Select LOCATION and press ENTER, which will open the Location menu.

NOTE:

If you want to unconfigure your fuel flow, select UNKNOWN from the Location menu.

5.Highlight the desired location and press ENTER. The following message will appear: Are you sure you wish to change this device's configuration?

6.Select YES and press ENTER. Press EXIT repeatedly to get back to the main display.

Unconfiguring an EP-60R Fuel Flow

You can unconfigure a fuel flow by manually resetting its Location to default settings (Unknown) via the Location menu or you can use the Restore Defaults command.

To reset the fuel flow's device name, refer to the previous segment covering Device Name. The Device Name also may be reset by using the Restore Defaults command.

NOTE:

If you execute the Restore Defaults command, you will have to re- enter your engine-tank configuration settings. The Restore Defaults command is covered at the end of this section.