Omega Engineering FP-6000 manual Sensor flange Alignment rod Direction of flow

Page 15

4.Place the alignment rod in the hole on the sensor flange. Align the flange so rod is parallel to the process pipe.

sensor flange

alignment rod

direction of flow

process pipe (top view)

The flow sensor alignment rod MUST be parallel to the process pipe as shown.

5.Thread upper hex nuts with lock-washers until they contact the sensor flange and tighten. Check for proper "H" dimension and readjust if necessary.

sensor flange

FLOW

cap nuts

upper hex nuts and lock-washers

jam nuts

5.95 in.

(151 mm)

brass sensor nut

1-1/2 in. NPT or ISO 7/1-Rc 1-1/2in.

female pipe fitting

lower

hex nuts

"H"

wall

thickness

10% of I.D.

pipe I.D.

FLOW

process pipe

9

Page 14 Page 16
Image 15
Page 14 Page 16
Contents
User’s Guide Servicing North America For immediate technical or application assistanceServicing Europe Table of Contents Page Important Safety Information Type Omega FP-6000 Series Warranty RecordChapter Introduction DescriptionTheory of Operation Chapter Installation and Wiring Location of FittingSensor Position +30 Sensor Wiring11/4 in mm diameter drill Pipe thread sealant Tape measure Standard Fitting InstallationHardware, Standard Sensor Hardware, Hot-Tap SensorHot-Tap Fitting Installation Remove brass sensor nut from sensorThread brass sensor nut into pipe fitting Wall Thickness Calculating the H DimensionHot-Tap Sensor = 15.00 pipe wall thickness 0.10 X I.D Record your pipes H dimension for future referenceStandard Installation Sensor flange Alignment rod Direction of flow Hot-Tap Installation StepThread one jam nut and lower hex nut onto Direction of flow Make sure the bleed valve is closed full clockwise positionUsing the Hot-Tap Installation Tool Protector plate Installation tool shaft Upper hex nuts Into the port to prevent damage ChapterStandard Sensor Removal Hot-Tap Sensor RemovalCap nuts Installation tool Chapter Maintenance and Replacement Parts MaintenanceReplacement Parts Rotor Replacement Procedure Conversion Stainless Steel Pipe Per Ansi B36.19 Mm = inches DimensionsDimensions for Standard Sensors Wrought Steel Pipe Per AnsiDimensions for Hot-Tap Sensors GPM/HZ LPM/HZ Factors Stainless SteelFactors Wrought Steel GPM/HZ LPM/HZ Factors Plastic PipeGeneral Data SpecificationsSpecifications WARRANTY/DISCLAIMER OMEGA…Of Course
Related manuals
Manual 32 pages 56.58 Kb