Omega Engineering FP-6000 manual Specifications

Page 30

Specifications

operating pressure:

225 psi (15 bar)

Maximum

operating temperature: 212°F (100 °C)

Caution: The FP-6002 and FP-6003 Series Hot- Tap system's overall specifications and limitations depend on the lowest maximum rating of the components associated with the system. For example, a ball valve, a component of the system, is rated at a maximum 100 psi @ 185°F, limiting the entire system's maximum pressure/temperature rating to 100 psi @ 185°F. All higher maximum specifications MUST yield to the component with the lowest maximum specification.

Note: Pressure/temperature specifications refer to sensor performance in water. Certain chemical limitations may apply. Chemical compatibility should be verified before sensor installation.

24

Image 30
Contents User’s Guide Servicing North America For immediate technical or application assistanceServicing Europe Table of Contents Page Important Safety Information Warranty Record Type Omega FP-6000 SeriesChapter Introduction DescriptionTheory of Operation Chapter Installation and Wiring Location of FittingSensor Position Sensor Wiring +30Hardware, Hot-Tap Sensor Standard Fitting InstallationHardware, Standard Sensor 11/4 in mm diameter drill Pipe thread sealant Tape measureHot-Tap Fitting Installation Remove brass sensor nut from sensorThread brass sensor nut into pipe fitting Calculating the H Dimension Wall ThicknessRecord your pipes H dimension for future reference Hot-Tap Sensor = 15.00 pipe wall thickness 0.10 X I.DStandard Installation Sensor flange Alignment rod Direction of flow Hot-Tap Installation StepThread one jam nut and lower hex nut onto Make sure the bleed valve is closed full clockwise position Direction of flowUsing the Hot-Tap Installation Tool Protector plate Installation tool shaft Upper hex nuts Hot-Tap Sensor Removal ChapterStandard Sensor Removal Into the port to prevent damageCap nuts Installation tool Chapter Maintenance and Replacement Parts MaintenanceReplacement Parts Rotor Replacement Procedure Wrought Steel Pipe Per Ansi DimensionsDimensions for Standard Sensors Conversion Stainless Steel Pipe Per Ansi B36.19 Mm = inchesDimensions for Hot-Tap Sensors Factors Stainless Steel GPM/HZ LPM/HZFactors Wrought Steel Factors Plastic Pipe GPM/HZ LPM/HZSpecifications General DataSpecifications WARRANTY/DISCLAIMER OMEGA…Of Course