Omega Engineering FP-6000 manual Sensor Wiring, +30

(max. 30°) will help to avoid these problem areas, but use caution. Excessive angles will cause bearing drag at lower flow rates.

On a vertical pipe run locate the sensor where the flow is upward. If downward flow is necessary the system must be designed to prevent air/water vapor pockets from developing in the pipe which will affect the performance of the sensor.

Maximum Sensor

Installation Range

Process Pipe

Figure 2

Sensor Installation Range

Vertical mounting is recom- mended to provide best overall performance.

2.3 Sensor Wiring

Both Standard and Hot-Tap sensor versions include 25 feet of cable. The cable may be extended up to 200 feet without amplification. A 1/2 inch conduit port is available in the sensor to install the cable in protective conduit.

1/2 in. conduit port

black (AC signal out)

red (AC signal out)

silver (shield)