Baldor MN735 manual Wire Size, AWG MM2

			Table 3-2 Wire Size
		Output				Wire Size
		Current
Catalog
	Size			L1, L2, L3, N,		DC+, DBR		TH1A, TH1B
Number		Cont.	Peak
				GND and Motor
		(Amps)	(Amps)
				AWG	MM2	AWG	MM2	AWG	MM2
ID35D8A1F5-CRH	1	1.5	2.3	12	2.5			12	2.5
ID35D8A2F2-CRH	1	2.2	3.3	12	2.5			12	2.5
ID35D8A03-CRH	1	3.0	4.5	12	2.5			12	2.5
ID35D8A04-CRH	1	4.0	6.0	12	2.5			12	2.5
ID35D8A07-CRH	2	7.0	10.5	12	2.5			12	2.5
ID35D2A10-CRH	3	10.5	15.8	10	2.5	10	2.5	12	2.5
ID35D2A16-CRH	3	16.5	24.8	10	2.5	10	2.5	12	2.5
ID35D4A1F5-CRH	2	1.5	2.3	12	2.5	12	2.5	12	2.5
ID35D4A02-CRH	2	2.0	3.0	12	2.5	12	2.5	12	2.5
ID35D4A2F5-CRH	2	2.5	3.8	12	2.5	12	2.5	12	2.5
ID35D4A4F5-CRH	2	4.5	6.8	12	2.5	12	2.5	12	2.5
ID35D4A5F5-CRH	2	5.5	8.3	12	2.5	12	2.5	12	2.5
ID35D4A09-CRH	3	9.0	13.5	10	2.5	10	2.5	12	2.5
ID35D4A12-CRH	3	12.0	18.0	10	2.5	10	2.5	12	2.5
ID35D4A16-CRH	3	16.0	24.0	10	2.5	10	2.5	12	2.5

Note: All wire sizes based on 75° C copper wire, 40° C ambient temperature, 4-6 conductors per conduit or raceway.

Power Connections The signals are shown in Figure 3-5 and described in Table 3-3.

1.Remove the cover, shown in Figure 3-2.

2.Loosen the grounded cable clamp, Figure 3-5.

3.Connect the Mains Cable, Motor Cable, Dynamic Brake Cable and Thermistor Cable wires, if used to their proper clamp terminal, Figure 3-5. Be sure the shields of all shielded cables are in contact with the grounded cable clamp.

Note: This control must have two separate mains earth grounds connected as shown in Figures 3-5 and 3-6.

4.Tighten the grounded cable clamp screws to securely hold the cables.

3–6 Receiving & Installation MN735