Baldor MN735 manual To prevent equipment damage, be certain that the input power

Caution:	To prevent equipment damage, be certain that the input power
	has correctly sized protective devices installed as well as a power
	disconnect.
Caution:	Avoid locating the control immediately above or beside heat
	generating equipment, or directly below water or steam pipes.
Caution:	Avoid locating the control in the vicinity of corrosive substances
	or vapors, metal particles and dust.
Caution:	Suitable for use on a circuit capable of delivering not more than
	the RMS symmetrical short circuit amperes listed here at rated
	voltage.	RMS Symmetrical Amperes
	Horsepower
	1.5–50	5,000
	51–200	10,000
	201–400	18,000
	401–600	30,000
	601–900	42,000
Caution:	Baldor recommends not using “Grounded Leg Delta” transformer
	power leads that may create ground loops and degrade system
	performance. Instead, we recommend using a four wire Wye.
Caution:	Logic signals are interruptible signals; these signals are removed
	when power is removed from the drive.
Caution:	The safe integration of the driver into a machine system is the
	responsibility of the machine designer. Be sure to comply with
	the local safety requirements at the place where the machine is to
	be used. In Europe this is the Machinery Directive, the
	ElectroMagnetic Compatibility Directive and the Low Voltage
	Directive. In the United States this is the National Electrical code
	and local codes.
Caution:	Controls must be installed inside an electrical cabinet that
	provides environmental control and protection. Installation
	information for the drive is provided in this manual. Motors and
	controlling devices that connect to the driver should have
	specifications compatible to the drive.
Caution:	Do not tin (solder) exposed wires. Solder contracts over time and
	may cause loose connections.
Caution:	Electrical components can be damaged by static electricity. Use
	ESD (electro-static discharge) procedures when handling this
	control.

2–4 General Information MN735