Sterling SSV-052R, SSV-05R operating instructions Control and Maintenance Unit

Page 18

3-2 Control and Maintenance Unit

A.The unit is switched ON and OFF at the control and maintenance unit.

B.At the regulator, the operating pressure is adjusted. A water separator is integrated.

C.Regularly inspect the compressed air filter to make sure that it is clean and functioning properly. Clean or replace this filter as needed. For information, see Section 5-1: Maintenance.

Figure 5: Control and Maintenance Unit

A

B

C

XSV-05, XSV-05/R, & XSV-05/2R Single Conveying Units - Venturi Style

17 of 36

Image 18

Contents SSV-05R Page Parts and Service Department Table of Contents Safety Instructions Page Explanations and Information Operating PersonnelFor Your Safety How to Use This ManualMaintenance Responsibility Unit Safety Installation General Information XSV-05 PartsInstalling the Conveyor Hopper Installing the Control and Maintenance Unit Control and Maintenance UnitConnecting the Compressed Air Supply Venturi AssemblyElectrical Connection Check with the local electricity board for regulationsFunctional Description Method of FunctioningControl and Maintenance Unit Setup Setting the Mixing Ratio of the Components XSV-05/2R UnitsPreparations Basic Setting of the Filling Level in the Conveyor Hopper Filling Level Too HighFine Adjustment of the Filling Level in the Conveyor Hopper Maintenance Maintenance Intervals DailyCleaning/Replacing the Filter Cartridge XSV-05Adjusting the Level Probe DisassemblyTroubleshooting ProblemPage Technical Data Dimension Sheet XSV-05/R XSV-05/2R Spare Parts Lists XSV-05R XSV-05/2R Position ID Number Designation Quick Start Guide -XSV Venturi Loader Technical Assistance Parts Department