Sterling SSV-052R Electrical Connection, Check with the local electricity board for regulations

Page 16

2-5 Electrical Connection

Check with the local electricity board for regulations.

The operating voltage is 110 V, AC, PE, 50/60 Hz. Special voltages available by request.

The connected load is approximately 15 W.

The connection is made using a mains connector. A separate protection of the socket is not necessary.

Connect the plug of the sensor cable to the control unit.

Plug the main connector into a corresponding socket.

XSV-05, XSV-05/R, & XSV-05/2R Single Conveying Units - Venturi Style

15 of 36

Image 16

Contents SSV-05R Page Parts and Service Department Table of Contents Safety Instructions Page Explanations and Information Operating PersonnelFor Your Safety How to Use This ManualMaintenance Responsibility Unit Safety Installation General Information XSV-05 PartsInstalling the Conveyor Hopper Installing the Control and Maintenance Unit Control and Maintenance UnitConnecting the Compressed Air Supply Venturi AssemblyElectrical Connection Check with the local electricity board for regulationsFunctional Description Method of FunctioningControl and Maintenance Unit Setting the Mixing Ratio of the Components XSV-05/2R Units SetupPreparations Basic Setting of the Filling Level in the Conveyor Hopper Filling Level Too HighFine Adjustment of the Filling Level in the Conveyor Hopper Maintenance Maintenance Intervals DailyCleaning/Replacing the Filter Cartridge XSV-05Adjusting the Level Probe DisassemblyTroubleshooting ProblemPage Technical Data Dimension Sheet XSV-05/R XSV-05/2R Spare Parts Lists XSV-05R XSV-05/2R Position ID Number Designation Quick Start Guide -XSV Venturi Loader Technical Assistance Parts Department