Sterling SSV-052R, SSV-05R operating instructions Maintenance

Page 22

Chapter 5: Maintenance

This chapter is intended for persons with skills in electrical and mechanical areas due to their training and experience.

Personnel using the information in this chapter must be educated about accident prevention, operating conditions, and safety regulations. Make sure that all personnel are informed accordingly.

For maintenance work taking place at heights of over approx. 6 ft., use only ladders or similar equipment and working platforms intended for this purpose. At greater heights, personnel must wear the proper equipment for protection against falling.

Use only suitable lifting gear, which is in proper working order, and load suspension devices with adequate carrying capacity.

Do not stand or work under suspended loads!

Make sure that the electric motors/switch cabinets are adequately protected against moisture.

Use only proper work shop equipment.

Before starting maintenance work, appoint a supervisor.

Inform the responsible personnel before any maintenance work on the system is started.

Never operate the equipment when it is partially disassembled.

All maintenance and repair work not described in this chapter may only be carried out by service personnel or authorized personnel (appointed by the manufacturer).

XSV-05, XSV-05/R, & XSV-05/2R Single Conveying Units - Venturi Style

21of 36

Image 22
Contents SSV-05R Page Parts and Service Department Table of Contents Safety Instructions Page Explanations and Information Operating PersonnelFor Your Safety How to Use This ManualMaintenance Responsibility Unit Safety Installation General Information XSV-05 PartsInstalling the Conveyor Hopper Installing the Control and Maintenance Unit Control and Maintenance UnitConnecting the Compressed Air Supply Venturi AssemblyElectrical Connection Check with the local electricity board for regulationsFunctional Description Method of FunctioningControl and Maintenance Unit Setting the Mixing Ratio of the Components XSV-05/2R Units SetupPreparations Basic Setting of the Filling Level in the Conveyor Hopper Filling Level Too HighFine Adjustment of the Filling Level in the Conveyor Hopper Maintenance Maintenance Intervals DailyCleaning/Replacing the Filter Cartridge XSV-05Adjusting the Level Probe DisassemblyTroubleshooting ProblemPage Technical Data Dimension Sheet XSV-05/R XSV-05/2R Spare Parts Lists XSV-05R XSV-05/2R Position ID Number Designation Quick Start Guide -XSV Venturi Loader Technical Assistance Parts Department