BM 2610012089
Saw Operations
Chop Cut
•The slide rail lock knob is tightened and the head assembly is lowered to cut through the workpiece.
•This type of cut is used mainly for narrow pieces.
follow these instructions for making your chop cut:
1.Slide the head assembly to the rear as far as it will go (Figure 30).
2.Tighten the slide rail lock knob (Figure 30).
3.Properly position workpiece. Make sure work- piece is clamped firmly against the table and the fence.
Use clamping position that does ! WARNING not interfere with operation. Before
switching on, lower head assembly to make sure clamp clears guard and head assembly.
4.Activate the switch. Lower the head assembly and make your cut.
5.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.
Slide Rail
lock Knob
Slide Completely
Against Rest
figure 30. Chop Cut
Slide Cut
•The slide rail lock knob is loose, the head assem- bly is pulled towards the operator, the head assem- bly is lowered to the workpiece and then pushed to the rear of the saw to make the cut.
•This type of cut is used mainly for wide pieces.
•A positive blade hook of 10 degrees or more is recommended for best performance when mak- ing aggressive cuts or cutting thicker materials.
NEVER pull the saw toward you ! WARNING during a cut. The blade can sud-
denly climb up on top of the workpiece and force it- self toward you.
follow these instructions for making your slide cut:
1.Properly position workpiece. Make sure work- piece is clamped firmly against the table and the fence.
!WARNING Use clamping position that does not interfere with operation. Before
switching on, lower head assembly to make sure clamp clears guard and head assembly.
2.Loosen the slide rail lock knob.
3.Grasp the switch handle and pull the head as- sembly away from the fence, until the blade clears the workpiece or to its maximum extension if blade cannot clear the workpiece (Figure 31).
4.Activate the switch. Lower the assembly all the way down and cut through the edge of the work- piece.
5.Push (but do not force) the head assembly to- wards the fence to the full rear position to com- plete the cut.
6.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.