BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:42 AM Page 32
Saw Operations
Crown Molding laying flat on Table
•Notes: Position workpiece with its back flat on the saw table.
•Always place top edge of molding against fence (Decorative edge is at the bottom of crown mold- ing.)
•"Spring angle" refers to angle between wall and crown molding.
•Cutting crown molding flat on the table can be done either as a chop cut or a slide cut depending on the width of the workpiece.
1.For 90º corner, set the bevel and miter angles using Charts below. Tighten the miter lock knob and the bevel lock lever (Figure 39).
2.Position molding on saw table. Clamp workpiece in place using the quick clamp.
Use clamping position that does ! WARNING not interfere with operation. Before
switching on, lower head assembly to make sure clamp clears guard and head assembly.
3.Follow procedures for either chop cut or slide cut (see page 26).
4.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.
NOTE: AlWAYS TAKE A TEST CUT USING SCRAp TO CONfIRM CORRECT ANGlES.
Clamp
Crown
Molding
33.9° Bevel | 31.6° Miter |
figure 39. Crown Molding laying flat
Miter and Bevel Settings for Standard Crown Molding Cuts
(When Crown Molding is lying flat on Table)
Assumptions: Molding is milled consistently. Corner is exactly 90º.
Molding Spring Angle is 38 degrees
| Miter | Bevel |
| (Table) | (Tilt) |
| Setting | Setting |
|
|
|
Inside Corner |
|
|
Left end (A) | (31.6) Right | (33.9) Left |
Use the left end |
|
|
of the cut |
|
|
Right end (B) | (31.6) Left | (33.9) Right |
Use the right end |
|
|
of the cut |
|
|
Outside Corner |
|
|
Left end (C) | (31.6) Left | (33.9) Right |
Use the left end |
|
|
of the cut |
|
|
Right end (D) | (31.6) Right | (33.9) Left |
Use the right end |
|
|
of the cut |
|
|
Molding Spring Angle is 45 degrees
| Miter | Bevel |
| (Table) | (Tilt) |
| Setting | Setting |
|
|
|
Inside Corner |
|
|
Left end (A) | (35.3) Right | (30.0) Left |
Use the left end |
|
|
of the cut |
|
|
Right end (B) | (35.3) Left | (30.0) Right |
Use the right end |
|
|
of the cut |
|
|
Outside Corner |
|
|
Left end (C) | (35.3) Left | (30.0) Right |
Use the left end |
|
|
of the cut |
|
|
Right end (D) | (35.3) Right | (30.0) Left |
Use the right end |
|
|
of the cut |
|
|