Bosch Power Tools 4310 Miter Cut, Bevel Cut, Follow these instructions for making your miter cut

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:41 AM Page 27

Saw Operations

Miter Cut

•A“miter cut” is a cross-cut made with the blade vertical (non-tilted) at a horizontal angle relative to the fence.

•A miter cut is made at 0° bevel and any miter angle in the range from 52° left to 60° right.

•The miter scale shows the angle of the blade relative to the fence angle is cast-in on the table for easy reading.

•Positive detents have been provided for fast and accurate mitering at 0°, 15°, 22.5°, 31.6° and 45° left and right and 60° right.

•The crown molding detents (left and right) are at 31.6° (See Cutting Crown Molding for more infor- mation page 32).

•For precision settings at angles next to the detents, use the detent override to lock out the detent. This prevents the wedge on the detent lever from slipping back into the detent.

•A miter cut can be made as either a chop cut or a slide cut, depending on the width of the workpiece.

•The kerf inserts should be as close to the blade as possible without touching the blade (see Kerf In- serts for adjustment procedures).

follow these instructions for making your miter cut:

1.Loosen miter lock knob. Lift miter detent lever and move the saw to the desired angle, using either the detents or the miter scale. Tighten miter lock knob (Figure 32).

2.Extend the base extensions and fence on the side on which the cut will be made. (See Sliding Fence and Base Extension on page 25).

3.Properly position workpiece. Make sure work- piece is clamped firmly against the table or the fence.

Use clamping position that does ! WARNING not interfere with operation. Before

switching on, lower head assembly to make sure clamp clears guard and head assembly.

4.Follow procedures for either chop cut or slide cut (see page 26).

5.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

Quick

Action-

Clamp

Workpiece	Miter
		Detents	Miter lock
	Scale
			Knob

figure 32. Miter Cut

Bevel Cut

•A “bevel cut” is a cross-cut made with the blade perpendicular to the fence but tilted away from the vertical position.

•A bevel cut is made at 0° miter and any bevel angle in the range up to 47°.

•There are factory set bevel stops at 0° and 45° on both the left and right. (See Adjustment section if adjustments are required.)

•The front-positioned bevel range selector knob provides three bevel range choices.

•There are also positive crown molding bevel stops at 33.9° on both the left and right. Disengage this stop unless using the 33.9° angle (See Cutting Crown Molding for details.)

•A bevel cut can be made as either a chop cut or a slide cut depending on the width of the workpiece.

•The front-positioned bevel lock lever locks the head assembly at the desired bevel angle.

-27-