Shindaiwa DGW310DMC, DGW310MC owner manual Elcb has activated, Slow-down』Feature

(3) The ELCB has activated

Caution: Electric Shock/Injuries

Be sure to disconnect all the loads to the equipment when turning the breaker ON again after ELCB has activated.

ELCB lamp (Red) turns ON and the breaker lever positions at the middle of and OFF .

In that case, reset the ELCB per the following procedure after having finished the leaked points.

1.Push the reset button.

2.Push the breaker lever down to OFF .

			『	』	『	』	『ＯＮ』	『	』
The above procedure brings restoration of the breaker lever to						ON .
Caution		＞
＜
	In the case ELCB monitor lamps keep OFF on using, it means that

AC Output over supply or AC output Supply under output selector switch positions at ECO. Refer to 9-3.

Operation to recover. 『

5-7. Slow-down』Feature

The Slow-down feature is to set the engine speed low automatically (in about 8seconds) for the purpose of reducing noise and fuel consumption, whenever no welding operation or electric supply is performed.

In the case of using the Slow-Down feature, turn the slow-down switch to ON. By the condition, the engine automatically moves to high speed, whenever welding operation or electric supply starts.

△Caution: Damage to properties

When using the load with magnet switch, turn the slow-down switch OFF .

Caution				『	』
＜	＞
	When the load less than 0.5A are connected to use, the slow-down feature does not function
	sometimes. So, turn the switch OFF .
		『	』		OFF .
	When welding and AC supply are used alternately or intermittently, turn the switch
			『	』	『	』
	When the output selector switch is at			ECO ,the engine does not turn to high speed.

15