Shindaiwa DGW310MC, DGW310DMC owner manual Fuel, Engine Oil and Water Leakage

Page 20

Mixture ratio of the coolant should be 30%-45% depending on the ambient temperature. Replace LLC at every year or 2000 hours.

Recommended LLC concentration (for reference only)

 

 

 

 

 

 

 

Lowest Temp.

-15

-20

-30

 

 

 

 

 

 

Mixture Ratio

 

30%

35%

45%

6-3 Fuel

Caution: Fire

Always wipe any drip of fuel. Do not use the equipment when any leak is found. Repair the equipment before use.

Check the fuel level and add the fuel if it is necessary.

Caution

 

 

 

 

 

 

 

Use Diesel Fuel JIS No.2 in the event ambient temperature down to -5

 

In colder area, use JIS No.3 (down

 

To -15 .)or JIS No. Special 3

 

(down to -25

 

)

 

Always use fuel strainer in the

 

fuel inlet.

 

 

 

Fill the fuel tank slightly less

 

than the FULL tank.

 

 

Fuel Inlet

6-4.Fuel, Engine Oil and Water Leakage

Tank Cap

Strainer

Caution: Fire

Do not use the equipment when any leak is found. Repair the equipment before use.

Be sure to check any leakage for fuel, oil and coolant/water at the hose connections by opening the side doors. Whenever checking leakage, turn the fuel lever OPEN and be sure to close the fuel lever after checking.

18

Image 20
Contents DGW310DMC DGW310MC Page Introduction Other types of caution Even som e of the items notedSafety Guidelines Page Page Location of warning labels Specifications DGW310DMC DGW310MCUse DGW310DMC DGW310MC DGW310DMC Eco Welding DisplayFrequency Selection Monitor LampOil Pressure Monitor Lamp Water Temperature Monitor LampBattery Charge Monitor Lamp Remote Control Box Option How to connect remote control boxElcb and Grounding Grounding Operation CheckStop RUN StopSlow-down』Feature Elcb has activatedSAE30 SAE20 Filling the radiator Filling the sub tankFull Fuel Fuel, Engine Oil and Water LeakageBattery Fluid level is lower than the Lower levelStarting StartKeep the engine idle for about 5 minutes Stopping Selection Welding CablePolarity Connection Welding CableWelding DGW310DMCMIN MAX ECO ECODGW310MC P 200/220V 3-P 4-Wires Output Range21-P 200/220V P 100/110VOutput Power ConsumptionOutput Limitation Operation 』29 Simultaneous use of Generating and Welding Check and Maintenance Check Time Check Items Startup 1Change Engine Oil Clean/Change Air Element Change Oil FilterClean/Change Fuel Strainer CloseLong-Term Storage Change Coolant/WaterTroubleshooting Regular Dual( ) Memo