Shindaiwa DGW310MC, DGW310DMC owner manual

Page 6

Caution: Burns

Do not touch the engine and muffler during operation and immediately after stopping the equipment,

for the temperature can reach extremely high.

When checking engine oil or changing oil, always stop the engine, and wait until the engine cools down. If you open either the oil gauge or the oil plug during operation, hot oil may cause some

injuries.

Be sure to wear leather gloves, apron, shoe covers, eye protection glass (es) (mask), safety shoes,

and safety cap and long sleeve shirts, because welding splashes spatters.

Caution: Injuries

When lifting the equipment, always use a lift hook. Do not lift the handle, for it may cause the

equipment to drop due to handle breaking off.

When carrying the equipment by truck, fix it strongly to keep the equipment from sliding as roping

two points of handle.

Always place the equipment on a flat and stable surface, to keep it from sliding. Be sure to lock the

wheels for with wheel type.

When starting the engine, turn off the connected equipment

And set the circuit breaker to OFF

position.

Do not move the equipment during operation.

When performing equipment check and maintenance, always stop the engine.

Do not operate the equipment if the equipment are modified or parts are removed

4

Image 6
Contents DGW310DMC DGW310MC Page Introduction Other types of caution Even som e of the items notedSafety Guidelines Page Page Location of warning labels Specifications DGW310DMC DGW310MCUse DGW310DMC DGW310MC DGW310DMC Frequency Selection Eco WeldingDisplay Monitor LampWater Temperature Monitor Lamp Battery Charge Monitor LampOil Pressure Monitor Lamp Remote Control Box Option How to connect remote control boxElcb and Grounding Stop RUN GroundingOperation Check StopSlow-down』Feature Elcb has activatedSAE30 SAE20 Filling the sub tank FullFilling the radiator Fuel Fuel, Engine Oil and Water LeakageBattery Fluid level is lower than the Lower levelStarting StartKeep the engine idle for about 5 minutes Stopping Selection Welding CablePolarity Connection Welding CableWelding DGW310DMCECO DGW310MCMIN MAX ECO 21-P 200/220V P 200/220V 3-P 4-WiresOutput Range P 100/110VPower Consumption Output LimitationOutput Operation 』29 Simultaneous use of Generating and Welding Check and Maintenance Check Time Check Items Startup 1Change Engine Oil Clean/Change Air Element Change Oil FilterClean/Change Fuel Strainer CloseLong-Term Storage Change Coolant/WaterTroubleshooting Regular Dual( ) Memo