Shindaiwa DGW310DMC, DGW310MC owner manual Check and Maintenance

Page 33

11. Check and Maintenance

Danger: Electric Shock/Injuries

Before checking, stop the engine and remove the engine key which to be kept by the person to do.

Do not open the doors during operation or just after, because the cooling fan or driving belts can enwind the body.

￿Danger: Burns

Never open a radiator cap during operation or just after operation, because of avoid burns from hot vapor.

Caution: Fire/Burns

Keep the equipment far away from fire.

Do not touch the engine and muffler during operation or immediately after stopping the equipment, for the temperature reaches extremely high.

￿Caution: Injuries to eyes and skin

Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or on clothing.

If the fluid comes in contact, especially with eyes, flush with a lot of Water and contact to a physician immediately.

￿Caution: Explosion

Do not use the equipment or charge the battery, in the case the battery fluid level is lower than LOWER

level.

Battery may emit some combustible gas, so keep it away from fire and sparks.

Caution

Besidespre-check before operation, qualified person only should do check and maintenance. Our authorized distributor or our service section only should do the job marked in the table.

Use the genuine parts only for replacement.

Use the tray to receive when draining the waste fluids.

Be sure to comply with the regulations when discarding hazardous substances such as oil, fuel, coolant (LLC),

battery, etc.

To protect the environment, never discard the waste fluid to the grounds, the rivers, lakes, the oceans,filter,

etc.

To optimize the use of the equipment, be sure to perform the check and maintenance based on the following table. Use the hour meter on it as rough standard for operation time

31

Image 33
Contents DGW310DMC DGW310MC Page Other types of caution Even som e of the items noted IntroductionSafety Guidelines Page Page Location of warning labels DGW310DMC DGW310MC SpecificationsUse DGW310DMC DGW310MC DGW310DMC Display Eco WeldingFrequency Selection Monitor LampWater Temperature Monitor Lamp Battery Charge Monitor LampOil Pressure Monitor Lamp How to connect remote control box Remote Control Box OptionElcb and Grounding Operation Check GroundingStop RUN StopElcb has activated Slow-down』FeatureSAE30 SAE20 Filling the sub tank FullFilling the radiator Fuel, Engine Oil and Water Leakage FuelFluid level is lower than the Lower level BatteryStart StartingKeep the engine idle for about 5 minutes Selection Welding Cable StoppingConnection Welding Cable PolarityDGW310DMC WeldingECO DGW310MCMIN MAX ECO Output Range P 200/220V 3-P 4-Wires21-P 200/220V P 100/110VPower Consumption Output LimitationOutput Operation 』29 Simultaneous use of Generating and Welding Check and Maintenance Check Time Check Items Startup 1Change Engine Oil Change Oil Filter Clean/Change Air ElementClose Clean/Change Fuel StrainerChange Coolant/Water Long-Term StorageTroubleshooting Dual Regular( ) Memo