Shindaiwa DGW310DMC, DGW310MC owner manual 』29

Caution

＜

The AC volt meter reads 3-P 200/200V apart from the circuit breakers position at

ON

or

OFF

when the engine driving.

After the engine starts

Refer to 7-1.Starting

, operate as per the following procedures.

1 Turn the power switch off on the load.

2 Check and confirm the breakers position at OFF .

＞

『

』

『

』

3 Select the correct frequency, designated in the loads.

4 Connect the loads to receptacle or terminals.

5 Close the terminal cover and fix it with the bolts.

6 Turn the breakers to ON .

『

』

（

Output

DMC

MC

Terminal

3-P/1-P 200/220V

Cover

Output Terminals

1-P 100/110V

『

』

Receptacle

Breaker

Breaker

Receptacle

Output Terminals

Terminal

Cover『

』

1-P 100/110V

1-P/3-P

Output Terminals

200/220V

Output

Terminals

Return -The circuit breaker has activated due to overload

Caution: Injuries

Be sure to turn the power switch to OFF on the load when returning the circuit breaker to ON again, when the circuit breaker has activated.

When the electric supply exceeds the rated output, the breaker activates to trip in order to shut down the

circuit. Check the breakers when the load stops operation.

ELCB lamp is to turn OFF in the case of overload shutdown. When the lamp keeps ON, refer to 5-6.

ELCB and Grounding .											『
			』
When any breaker has activated, return the circuit breaker per the followings procedure.
	1 Turn OFF all the power switches on the loads.
	2 Once push down the breaker lever to OFF					, push up the lever to		『	ON .
Caution		＞		『	『	』29	』		』
＜									『	』
	Take care for overload, referring to				9-2 Output Limitation
	The breaker activates when having used AC output in the selector switch at									ECO position. In the
	case stop using AC supply and return the breaker as above.