Shindaiwa DGW310DMC, DGW310MC owner manual Filling the sub tank, Full, Filling the radiator

Page 19

6-2. Coolant and Water

Danger: Injuries

Close all doors and locks during operating equipment to avoid injuries by accidental touch cooling fan or fan belt.

Danger: Burns

Do not open the radiator cap while operating the equipment or immediately after stopping the equipment to avoid sustaining burn from hot vapor.

￿Caution: Burns

Do not touch the engine or muffler during operation or immediately after stopping the equipment for the temperature can reach extremely high.

Check to see if the coolant/water level is between

FULL and LOW in the sub tank.

If it is below

 

 

 

 

LOW level, fill he tank and the radiator accordingly.

 

 

 

 

 

 

 

(1) Filling the sub tank

 

 

 

 

 

1.

Remove the sub tank cap.

 

 

 

Cap

2.

Fill up the sub tank to

FULL

level.

 

 

 

3. Install the cap again.

 

 

 

 

Sub Tank

 

 

 

 

 

 

 

(2) Filling the radiator

 

 

 

 

 

1.

Open the top plate.

 

 

 

 

 

2.

Remove the radiator cap.

 

 

 

 

3.

Fill the radiator up to the top/

 

 

 

 

4. Install the cap again and tighten.

 

 

 

5.

Close the top plate.

 

 

Sub tank

Caution

Use LongLife Coolant to prevent from freeze and rust. (30% mixture LLC is filled when shipped out from factory)

17

Top Door

Radiator

Cap

Water Inlet

Image 19
Contents DGW310DMC DGW310MC Page Other types of caution Even som e of the items noted IntroductionSafety Guidelines Page Page Location of warning labels DGW310DMC DGW310MC SpecificationsUse DGW310DMC DGW310MC DGW310DMC Monitor Lamp Eco WeldingDisplay Frequency SelectionBattery Charge Monitor Lamp Water Temperature Monitor LampOil Pressure Monitor Lamp How to connect remote control box Remote Control Box OptionElcb and Grounding Stop GroundingOperation Check Stop RUNElcb has activated Slow-down』FeatureSAE30 SAE20 Full Filling the sub tankFilling the radiator Fuel, Engine Oil and Water Leakage FuelFluid level is lower than the Lower level BatteryStart StartingKeep the engine idle for about 5 minutes Selection Welding Cable StoppingConnection Welding Cable PolarityDGW310DMC WeldingDGW310MC ECOMIN MAX ECO P 100/110V P 200/220V 3-P 4-WiresOutput Range 21-P 200/220VOutput Limitation Power ConsumptionOutput Operation 』29 Simultaneous use of Generating and Welding Check and Maintenance Check Time Check Items Startup 1Change Engine Oil Change Oil Filter Clean/Change Air ElementClose Clean/Change Fuel StrainerChange Coolant/Water Long-Term StorageTroubleshooting Dual Regular( ) Memo