11.Use a Phillips screwdriver to remove the screws that secure the two metal jumpers to the terminal block, as shown in Figure 9, then remove both jumpers. Be careful not to mix up the locations of any of the wires while you do so.
Figure 9. Changing motor jumper positions.
12.Place both of the jumpers into the 110V loca- tion shown in Figure 8.
13.Replace the screws you removed in Step 11, making sure all wires are secured in the same positions they were originally in, as shown in Figure 8. Refer to SECTION 8: WIRING starting on Page 45 for detailed wir- ing diagrams.
14.Install a NEMA 5-20 plug such as the one shown in Figure 3 onto the power cord, as illustrated in Figure 10. Refer to SECTION 8: WIRING starting on Page 45 for detailed wiring diagrams.
Cord Rewired for 110V
Neutral
Hot |
| |
Ground | (As Recommended) |
Figure 10. Cord rewired for 110V.
Model G0705 (Mfg. since 09/09) |